Hi Jensl,
I was able to have the drive seen when installing Server 2012.
It appears that the Server 2012 install disk/iso does not have the necessary files to support the Intel SATA ports on this board when they are set to AHCI mode. If you change them to IDE mode you can install the OS.
To change the Intel ports to IDE do the following:
- access the BIOS
- Select Intel RC Setup
- Select Southbridge Chipset Configuration
- Select SATA Configuration
- Assuming you are on the SATA_0 or SATA _1 port, scroll down to the SATA 3 Controller section and change the mode to IDE (if you on SATA_2-5, change the SATA 2 Controller mode).
I've scoured the ASROCK site and the Intel site looking for AHCI drivers for the Atom C2750 SoC that is on this board but I haven't had any luck yet. I'll keep looking. You might try contacting ASRock if you have a chance.
