I am using Intel Galileo GEN 2 board.
I use Eclipse Juno with Arduino 1.5.3-Intel1.0.4 and plugin 2.2.
Everytime I give a upload sketch I receive the below message. Compilations being successful.
Starting upload
using arduino loader
Launching
Output:
upload failed
I want to run the blink program on to the Gen 2 board. I have checked the IDE path and the board and port selected to be proper.
Can anyone suggest on troubleshooting this.?
A point to be noted is that whenever I choose any option from project properties I receive the following CDT scanner error from it.baeyens.arduino LanguageSettingsProvider. But this does not impact compilation or any major stuff.
Message was edited by: Nanda sahu